Altec-lansing 3300A Instrukcja Użytkownika Pobierz pdf (Strona 11)

Operating Instructions for the Altec Lansing 3300A Series Mixing Consoles

5x20 mm (supplied) fuse is

installed in the fuse holder.

3. Change the chassis-

mounted switch on the

connector panel to the

correct corresponding

voltage.

4. Plug the power cord in the

desired ac line and resume

normal operation.

CAUTION: Before attempting

to move this switch, the mixer

must be turned off and the

power cord disconnected.

Slo-Blo® is a registered trademark of

Littelfuse®, Inc.

5 MOVEABLE REAR PANEL

ON THE 3308A MIXER

One example of the versatility of the

3308A mixer is that it can be either

rack-mounted in a standard 19-inch

equipment rack or mounted in a

table-top. To accommodate a rack-

mount instaUation, the 3308A is

supplied with its connector panel

placed on its bottom. This prevents

the input/output connectors from

using up valuable vertical rack space.

Figure 9. 3308A moveable rear panel.

The connector panel may be moved <

to the rear of the mixer to

accommodate a table-top installation.

Refer to Figure 9 to move the

connector panel to the rear. When

moving this panel to the rear, care

should be taken not to pinch any

cables between the two panels.

WRITE-ON LABELS

In order to label each channel

without marring the surface of the

mixer, removzible stick-on labels are

available from any office supply

outlet. Labels that are recommended

are Presaply® Removable Labels by

Dennison; part number Den-43-540;

dimensions are %" X 1".

ALTEC LANSING^ CORPORATION • a Mark IV Company

1 2 ... 6 7 8 9 10 11 12 13 14

Komentarze do niniejszej Instrukcji

Brak uwag

Altec-lansing 3300A Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji