Altec-lansing 3300A Instrukcja Użytkownika Pobierz pdf (Strona 6)

Operating Instructions for the Altec Lansing 3300A Series Mixing Consoles

Figure 5. Output section controls.

freedom from clipping

distortion. If the fader must run

wide open to get enough, level,

turn up the TRIM control

judiciously or increzise the level

setting of the left and right

su/jointfilesconvert/1697082/bgroup controls. Conversely,

if the fader must be pulled way

back to get the right level, the

TRIM control or ;ereo

su/jointfilesconvert/1697082/bgroup should be adjusted.

Adjust the TRIM control ii’ the

PEAK LED lights, otherwise ad

just the stereo su/jointfilesconvert/1697082/bgroups. For

optimum performance, the

channel FADERS should be run

close to the "0" mark.

4.2 Output Section Controls

(Refer to Figure 5.)

1. TO MON Send (AVX 1. AUK

2): The TO MON level control

determines the amount of exter

nally generated effects signals

in the monitor mix. With the

use of this control, the

performers can hear the added

effects in their monitors.

2. Effects SEND (AUX1,AUX2):

The effects SEND control sets

the level of the signal appearing

at the effects send output

jack(s) going to any type of

outboard effects device(s) such

as a digital reverb. Hanger,

compressor/limiter, etc. The

source of this signal is via the

individual AUX 1 and AUX 2

send level controls on each

input channel.

3. Effects RETURN (AUX 1,

AUX2): The effects RETURN

level control determines the

amount of externally generated

effects signals in the main mix.

This signal is mixed into the

left and right stereo sub

channels via the AUX 1 and

AUX 2 PAN control(s).

4. PAN Control (AUX 1, AUX

2): The effects PAN control

(AUX 1, AUX 2) directs the

signal coming from the effects

ALTEC LANSIN(f CORPORATION • a Mark IV Company

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Komentarze do niniejszej Instrukcji

Brak uwag

Altec-lansing 3300A Instrukcja Użytkownika Strona 6

Komentarze do niniejszej Instrukcji